Omega Excalibur Solace keyless remote FCC ID SY9PANDALARM870 alarm Key fob car SRSST1W starter transmitter control - Pre-owned White LED 2RED14po

This is ONE (1) Solace Aftermarket Installed keyless remote control transmitter vehicle starter.

https://fccid.io/SY9PANDALARM870/User-Manual/Manual-525913.pdf

How to learn new code:

1. Put the car key into the key lock, press the valid (valet)switch 5 seconds, the siren will chirp 5 times and the LED indicator is ON .

2. Press any button on one of the transmitters until the siren chirps 2x s. finish the first transmitter code learning.

3. Press any button on the 2nd transmitter until the siren chirps 3x s. Finish the 2nd transmitter learning.

4. Press any button on the 3rd transmitter until the siren chirps 3x s. Finish the 3rd transmitter learning.

5. After finishing all 4 transmitters code learning, the LED indicator is OFF. Max. 4 transmitters can be programmed to this system.

6. You can learn only one transmitter within 10 seconds after the siren chirps finish. Within this 10 seconds, if you do not press any button on the transmitter or take off the car key, code learning will finish.

7. Every time learning code, please learn all 4 transmitters to make the lost remote transmitter invalid.

TRANSMITTER LEARNING
Important! The remote starter will hold 3 transmitter
codes. It is recommended that when programming in
transmitters, you fill up all four transmitter codes, even
if only using one or two transmitters. This will clear
all other transmitter coding from the unit and prevent
stray coding or possible interference from other remote
transmitters.
1. Turn ignition ON-OFF-ON.
2. Press the valet switch TWICE (button) in the
antenna, siren/horn (optional) will chirp once each
time button is pressed.
3. Press and hold the valet switch, siren/horn will
chirp 3 times & parking lights will turn on to
indicate you have entered Transmitter Learning
Mode.
4. Press button 1 (Lock) of every transmitter to
be coded. The siren/horn will chirp once and
the parking lights will flash once to indicate
successfully learning. System will exit Learn
Mode and lights will turn off after 15 seconds of
no activity.
5. Turn ignition OFF and the unit will exit code-
learning mode.