Condition: Pre-Owned 229po
Reg. Price: [price_original_slashed_nobr]
Our Price: [price_for_sale]
Quantity [quantity_box_show]
In-Stock. May ship same day if ordered by 12pm.
Compatible Vehicles
FOR THIS FCC ID / PART #
Mazda Millenia Years: 1996 1997 1998 1999 2000
Unsure if this is compatible with your vehicle?
Your vehicle may need a different FCC ID / Part Number depending on your installed Remote Keyless Entry System (RKE): Factory, Dealer or Aftermarket. If you are unsure what system is installed, check your current remote, send us a photo, or contact us.
check compatibility
This is ONE (1) FACTORY original OEM - ready to program keyless remote control transmitter that will work for your vehicle's compatible installed Factory Original Equipment O.E.M. RKE (remote keyess entry) system. Compatibility 1: FCC ID/Part number on the back of your CURRENT remote MUST match with FCC ID and PART # listed below.
This is ONE (1) FACTORY original OEM - ready to program keyless remote control transmitter that will work for your vehicle's compatible installed Factory Original Equipment O.E.M. RKE (remote keyess entry) system. Compatibility 1: FCC ID/Part number on the back of your CURRENT remote MUST match with FCC ID and PART # listed below.
Specifications
Condition
Pre-Owned 229po
FCC ID
KPU41048
Part#
2288101275
CANADA: 2288 101 275
NALDEC OMRON CORPORATION
MADE IN JAPAN
Dealer part #
2288 101 275
Buttons
4: Lock, Unlock, Trunk, Panic
Frequency
315 MHz
Battery Type
1: CR2025
Additional Information
Condition Explanation: Pre-Owned
Used: An item that has been used previously. The item may have some signs of cosmetic wear, but is fully operational and functions as intended. Scroll through listing for full details and description of any imperfections.
___________________________________________
PROGRAMMING INSTRUCTIONS
1. Remove key from ignition.
2.Close all doors.
3.Open driver side door and leave open.
4.Insert key in ignition, Turn key to ON (as far as you can go without starting the engine) and OFF, Remove Key.
5. Repeat step 4 two more times, making sure you remove key each time.
6.Close and then open the driver s door three times.
7. Buzz sound or chime should be heard at this point signaling that the vehicle is now in programming mode. If not, wait 40 seconds and return to step 1.
8.All transmitters need to be programmed at this time, including the old ones. Push any button on a transmitter two times. A buzz sound to chime should be heard at this point signaling that the vehicle has accepted the new transmitter code. Repeat for next transmitter, up to a total of three remotes (including any old remotes).
9. After all remotes are programmed, wait 15 seconds or until you hear four chimes signaling successful programming."
All remotes include working batteries (except case-only purchases)
A purchased remote needs to be programmed after you receive it in order to work with your specific vehicle