Condition: New 705Bno
Reg. Price: [price_original_slashed_nobr]
Our Price: [price_for_sale]
Quantity [quantity_box_show]
In-Stock. May ship same day if ordered by 12pm.
Compatible Vehicles
FOR THIS FCC ID / PART #
Honeywell 5800 series
Unsure if this is compatible with your vehicle?
Your vehicle may need a different FCC ID / Part Number depending on your installed Remote Keyless Entry System (RKE): Factory, Dealer or Aftermarket. If you are unsure what system is installed, check your current remote, send us a photo, or contact us.
check compatibility
This is ONE (1)Honeywell Ademco 5834-4 Four-Button Wireless Key Remote ready to program with battery installed aftermarket keyless remote control transmitter security house burglar alarm gate opener.
This is ONE (1)Honeywell Ademco 5834-4 Four-Button Wireless Key Remote ready to program with battery installed aftermarket keyless remote control transmitter security house burglar alarm gate opener.
Specifications
Condition
New 705Bno
FCC ID
CFS8DL5824
Part#
Dealer part #
Buttons
4; LED Green
Frequency
345 MHz
Battery Type
1: CR2032
Additional Information
Attention:
Please note there are several compatible remotes that look similar but not exactly like the photo pictured. We will do our best to ship you the remote pictured; however, the remote you receive may look different than the remote pictured. No worries, the board will program to your system the same.
_____________________________
Condition Explanation: Pre-Owned
Pre-Owned: An item that has been used previously. The item may have some signs of cosmetic wear, but is fully operational and functions as intended. Scroll through listing for full details and description of any imperfections.
_____________________________
Programming Instructions:
1) Enter programming mode. Frequently this accomplished by pressing: 6321 800 *56
2) Enter the zone number. Zones for wireless key fobs start at 26 and go to 41. Each button on the fob gets a different zone. If you already have 1 key fob then chances are zones 26-29 are already taken, which was my case. So I started with zone 30. Press: 30* (star moves you to the next menu).
3) Enter the "zone type." Some options are: 07 (audible alarm, i.e., panic), 20 (arm-stay), 21 (arm-away), 22 (disarm), 23 (no alarm response). For my arm-stay button, I pressed 20*.
4) Enter the "report code." I made sure it displayed "10" (all I had to do was press 1). This was based on something I read in a tech forum. Press *.
5) Enter the "input type." Since this is a button type, it should be 5. Press 5*.
6) Push the button on your key fob that you want to use. You'll need to hold it down long enough for the light on the fob to turn on. Then you'll need to do it again. In fact, I found I had to push the button 4 times for my system to record it. Then push * on the alarm pad to advance to the next menu.
7) At the enroll mode ("1A LC") screen, press: 0.
That should get you through 1 button on the key fob. You'll need to repeat for each button. Once done make sure you're on the zone screen (you may need to hit the * button a few times to get there), then press: 00. This exits you out of this level of programming but keeps you at the *56 level. You'll then need to press: *99 to get out of programming mode completely.
Now test your buttons to make sure they work.
All remotes include working batteries (except case-only purchases)
A purchased remote needs to be programmed after you receive it in order to work with your specific vehicle
This remote is compatible.
This remote is not compatible.
