Karr keyless remote conrol transmitter vehicle secuirty alarm starter CAR 200 CARR 2040 KAR 2040A ELVAR5C FCC ID ELVAT5H - Faded 575fo

Specifications

Condition	Faded 575fo
FCC ID	ELVAT5H
Part#
Dealer part #
Buttons	3: Panic, Arm / Dis., Trunk (opt); LED Red
Frequency	301 - 302 MHz
Battery Type	1: GP23A

---

Additional Information

Condition Explanation: Pre-Owned  & Faded Missing LED Light Cover

Pre-Owned:  An item that has been used previously. The item may have some signs of cosmetic wear, but is fully operational and functions as intended. Scroll through listing for full details and description of any imperfections. 

Faded: Graphics on buttons will be faded off. - see photo

Missing LED Light Cover: No LED Light Cover - see photo
_____________________________

Attention: Please note there are several compatible remotes that look similar but not exactly like the photo pictured. We will do our best to ship you the remote pictured; however, the remote you receive may look different than the remote pictured. No worries, the board will program to your system the same.      
_____________________________

This remote needs to be programmed to your vehicle in order for it to work with your vehicles’ installed RKE (remote keyless entry) system:

PROGRAMMING INSTRUCTIONS:

file:///C:/Users/DANPAR~1/AppData/Local/Temp/KARR%204040a.pdf

SEE PAGE 4 (ABOVE) to locate your Valet Button

 KARR 2040a 3 Button ELVAT5H Programming Instructions
Remote for system: KARR 2040a


    Enter the vehicle and turn the ignition to ON.
    Press the valet/programming button 3 times.  The LED will flash once, and the siren or horn will chirp once.
    Hold down the Arm/Disarm button for three seconds.  This will program button one.
    If your system is wired to use the trunk or panic buttons (if not skip to step 8,) press the valet/programming button once.  The LED will flash twice and the siren or horn will chirp twice.
    Hold down Trunk for three seconds.  The LED will flash and the siren or horn will chirp.
    If your system is wired to use the panic button (if not skip to step 8,) press the valet/programming button once.  The LED will flash and the siren or horn will chirp.
    Hold down Panic for three seconds.  The LED will flash and the siren or horn will chirp.
    Turn vehicle OFF.

• All remotes include working batteries (except case-only purchases)
• A purchased remote needs to be programmed after you receive it in order to work with your specific vehicle