Astrostart Module 392-1273-317 ID J5F-TX2000 Keyless Remote Control Entry Clicker Starter Transmitter Keyfob Key FOB Car Security Engine Vehicle Start - Pre-Owned 787o1

Specifications

Condition	Pre-Owned 787o1
FCC ID	J5F-TX2000
Part#	310-052-304-00 31005230400 CAN1851021168
Dealer part #
Buttons	6: Lock, Unlock, Trunk, Car Starter, Aux - LED Light; GREEN
Frequency	372.5 MHZ
Battery Type	3; CR2016

---

Additional Information

 Attention: Please note there are several compatible remotes that look similar but not exactly like the photo pictured. We will do our best to ship you the remote pictured; however, the remote you receive may look different than the remote pictured. No worries, the board will program to your system the same.

Condition Explanation: Pre-Owned

Pre-Owned:  An item that has been used previously. The item may have some signs of cosmetic wear, but is fully operational and functions as intended. Scroll through listing for full details and description of any imperfections. 
_______________________________________________________________________

http://auto.manualsonline.com/manuals/mfg/astroflex_electronics/4204a.html?p=6

Programming Instructions:

Four different remote controls can be programmed for a given vehicle. If a fifth remote is added, the first remote is deleted.

Note: When the first code learning command is sent, all the old codes are cleared out. therefore if you want to add a new remote, all the old ones must be reprogrammed as well.

One or more remote transmitters can be added. To do this, the programming is accessed as follows:

Open hood

Place key in the ignition and turn to the RUN position

Apply the brakes once

You now have 10 seconds to turn the key from the RUN to the OFF position 3 times.

If this sequence is correctly carried out, the control module flashes parking lights (4 flashes). You may then proceed to the next step.

Press the "key" button on the new remote control. When access code of new remote control is memorized, the control module will confirm with flashing parking lights (1 flash).

Repeat the above procedures for each remote control that has to be programmed (up to 4 remotes).

Apply the brakes.

New remote(s) is (are) now added to the system.

• All remotes include working batteries (except case-only purchases)
• A purchased remote needs to be programmed after you receive it in order to work with your specific vehicle